The Perfections In the Speaker System

Quite often we are asked the question of what to do in the event of a failure for one reason or another of one of the speakers of the speaker system. Or ask for advice on replacing some speakers to others in order to improve sound quality.

First of all, you need to know that each speaker has a number of electrical parameters – the so-called TC parameters (Till-Resin), which are used to calculate the acoustic design and crossover (filter). TS parameters are unique for each speaker, they are not repeated in different series, and even more so – from different manufacturers.

The First and the Main Problem

The first and main problem of the selection is that almost no manufacturer provides information about what kind of speakers are installed in loudspeakers – even the brand of the speaker is unknown, since there are usually no identifying marks on it, and it’s impossible to find out anything. In the best case, it will be an internal mark or designation – a non-talking set of letters and numbers.

And the second, equally important problem is that in the manufacture of acoustics, it is not the speaker that selects the existing body and crossover, but, on the contrary, takes the speaker and makes the body and crossover for it.

All this means that it is either not possible to pick up a similar speaker for mass-produced speakers, or such an attempt would involve a number of unjustified efforts and material costs, which would be almost comparable to the cost of the speaker itself.

However, it happens that the acoustics manufacturer uses serially produced and separately supplied speakers from manufacturers. In this case, if such models are still available, you can replace the speaker with exactly the same one. Or, better yet, replace a pair of speakers to eliminate the differences in the parameters of different batches. You can have the best details as you visit

Replacing the individual speakers for a particular speaker system with a different model, even the most eminent manufacturer, only leads to one thing: the inevitable reduction in sound quality, because all components of a particular speaker are chosen exclusively for harmonious collaboration, and even replacing one link can be for your acoustics fatal.

The solutions to the problem are as follows

The first is to go to the service center of the manufacturer of your loudspeakers. There are only two minuses: the repair period can be quite remote (especially if you have to wait for the delivery of the desired dynamics from abroad), and the cost of the work and materials will be very tangible.

  • If this is a manufacturer, then perhaps the dynamics data or speakers can be bought entirely from the hands on the radio market or by announcement.
  • Often it turns out to be more justified, simple and profitable another option: the acquisition of new acoustic systems will solve all the problems. In this case, you will not have to face the number of difficulties that we described above.
  • Exceptions are possible only for tweeters. For their selection, you need to know the resistance and landing dimensions of the tweeter. You can use our service of selection of tweeters. It is important to remember that the result of such a replacement does not guarantee the sound quality, and the tested speakers are not subject to return. That is, you will conduct this experiment at your own peril and risk (and at your own expense), and we will not be able to guarantee you the result in any way.

If you know exactly what kind of speakers have been installed in your speaker system, and they are in our range, then you can easily purchase them and make a replacement. In this case, you get the same sound as it was before the breakdown.